Allmand-brothers MLEX20-30KW V Bedienungsanleitung

11MAXI-LITEML 20 EX & ML 30 EX OPERATOR’S MANUALALLMAND BROS. INCP.O. BOX 888HOLDREGE, NE 68949PHONE: 308/995-4495, 1-800/562-1373ALLMAND FAX: 3

1010POWER UNIT INSTALLATION & START UP PROCEDUREFill the reservoir with automatic transmission uid or any clean hydraulic uid having a viscosity

101011 OPERATION AND SPECIFICATIONSSee the KUBOTA or ISUZU Engine Operator’s Handbook for further information on oil, fuel , and maintenance requi

1212 OPERATION AND SPECIFICATIONSBEFORE STARTING1. Fill the engine with the proper grade of lubricating oil (see pg. 11) and to cor-rect level

121213MODEL AND SERIAL NUMBERING SYSTEMSERIAL NUMBER LOCATIONTrailer: All MAXI-LITE EX V-SERIES models have a serial number plate located adjacent to

1414 OPERATION AND SPECIFICATIONSELECTRICALHard wired electrical circuits Easily serviceable componentized ballast assemblies.Ground rod Hour

141415MAXI-LITE ML EX V-SERIES DIMENSIONSHeight, Mast stowed : 101 in. (2.6 m)Height, Mast extended: 26’ 6” (8.1 m)Length

1616CONTROLS AND COMPONENTSNOTE: PHOTOGRAPHS MAY SHOW NON-STANDARD EQUIPMENT AND OPTIONSFIG. 1. CONTROL PANEL (KUBOTA)1. Switch, Circuit B

161617CONTROLS AND COMPONENTSNOTE: PHOTOGRAPHS MAY SHOW NON-STANDARD EQUIPMENT AND OPTIONSFIG. 3 CONVENIENCE OUTLET PANELIncludes:Main BreakerBreakers

1818CONTROLS AND COMPONENTSNOTE: PHOTOGRAPHS MAY SHOW NON-STANDARD EQUIPMENT AND OPTIONS46FIG. 6 FIG. 4 ENGINE (Left Side)Kubota V33001.

181819FIG. 4a ENGINE (Right Side)Kubota V33001. Air Cleaner2. Mufer3. Exhaust Manifold4. Upper Radiator HoseCONTROLS AND COMPONENTSNOTE: PHOTOGRAPHS

22INSPECTION CHECK LISTPREPARING THE MAXI-LITE ML EX V-SERIES FOR SERVICEThe MAXI-LITE ML EX Series requires service as well as proper operation in or

2020CONTROLS AND COMPONENTSNOTE: PHOTOGRAPHS MAY SHOW NON-STANDARD EQUIPMENT AND OPTIONSFIG. 81FIG. 6 OUTRIGGER JACK1. Pin --Retains outrigger in retr

202021CONTROLS AND COMPONENTSNOTE: PHOTOGRAPHS MAY SHOW NON-STANDARD EQUIPMENT AND OPTIONSFIG. 8 LIFTING EYE1. Lifting EyeFIGURE 8FIGURE 8aFIG. 8a FOR

2222CONTROLS AND COMPONENTSNOTE: PHOTOGRAPHS MAY SHOW NON-STANDARD EQUIPMENT AND OPTIONSFig. 11. Hydraulic Bypass Valve 1. Bypass Valve Allows

222223CONTROLS AND COMPONENTSNOTE: PHOTOGRAPHS MAY SHOW NON-STANDARD EQUIPMENT AND OPTIONSFig 12. Hydraulic Power Unit Assembly 1. Hydraulic Pu

2424CONTROLS AND COMPONENTSFIG. 16 Light Bar and Mounting Locations1. Light Bar2. Light mounting locations —Mount lamp xtures here for use 1FIG. 15

242425ROUTINE MAINTENANCE SCHEDULEKUBOTA V2203, V2003T AND V3300INSPECTION, MAINTENANCE, AND LUBRICATION SCHEDULECheck condition of the steel cable an

2626ISUZU 4LE1 INSPECTION, MAINTENANCE, AND LUBRICATION SCHEDULECheck condition of the steel cable and make sure it is properly secured. LUBRICAT

262627TROUBLESHOOTINGDANGER!HIGH VOLTAGE! DO NOT ATTEMPT TO TEST AND REPAIR GENERATOR AND BALLAST ELECTRICAL SYSTEMS UNLESS YOU UNDERSTAND AND ARE QU

28THIS PAGE LEFT BLANKINTENTIONALLY

223INSPECTION CHECK LIST ...2TABLE OF CONTENTS ..

44This manual provides the information necessary for the safe operation of the Allmand Bros., Inc., MAXI-LITE ML EX V-Series light tower.The MAXI-

445SAFETY AND WARNING DECALSSAFETY WARNINGALWAYS REPLACE ANY SAFETY AND INSTRUC-TION DECALS THAT BECOME DAMAGED, PAINT-ED, OR OTHERWISE ILLEGIBLE.

66SAFETY AND WARNING DECALSPART NO. 090158Location: AC control panelPART NO. 090166Location: Inside left hand door panelPART NO. 090163Location: On l

667SAFETY AND WARNING DECALSPART NO. 101057Location: On fuel tank near ller neck.PART NO. 090465Location: Inside left door panel.PART NO. 100247Loc

88HYDRAULIC LIFT VERTICAL MAST OPERATIONDESCRIPTION OF OPERATIONThe Allmand MAXI-LITE EX V Series hy-draulic lift tower assembly consists of a seven s

889HYDRAULIC LIFT VERTICAL MAST OPERATION VISUALLY INSPECT EQUIPMENT FOR DAMAGE BEFORE OPERATING. ALLOW ADEQUATE CLEARANCE AROUND TRAIL-ER FOR TOWE